I have concluded the Tensegrity Table………..I hope. It’s not turned out well but as I said to the budding designer, that’s life. It started out as a cast structure but that was totally out of court on cost grounds alone. Plasma cutting would be cheapish but then you have to factor in a lot of time with grinders and linnishers. Laser cutting is the answer but for a one off is expensive. I then had the thought of using maleable iron pipe. You can order it cut and threaded to length, Elbows and ‘T’ pieces are off the shelf as are small eyes that can be welded to it to take the tension wires. … citeste mai mult